Storing Measurement Values - Panasonic EW3109 Operating Instructions Manual

Storing Measurement Values
This product can store 90 measurement values.
After measurement, press the Memory/Recall button
while the
(M)
mark is blinking.
SYSTOLIC iwnHg DIASTOLIC mmHg
I JO
I JO
OJ
00
'E?
M/R
On/Otf
1
/
Storing is completed.
• Up to 90 measurement values can be stored. When
the memory is full and additional values are stored,
the oldest value in memory will be deleted and the
new value will be stored.
• If measurements could not be taken properly (the
E
mark is shown instead of the blood pressure value),
measurement values cannot be stored.
• However, even if the
E
mark is shown for the blood
pressure value, the pulse value will still be stored.
Number of stored data
r
\
To erase all measured values stored in memory:
1. Press the Memory/Recall button. The stored measurement values will
be displayed.
2. Press the same Memory/Recall button again, and hold it pressed until
the measurement values disappear (approximately 3 seconds or more).
* It is not possible to erase single measurement values.
3. The
HD
mark and
U
0 will be shown when all data is deleted.
v_
To switch off the blood pressure monitor, press the
On/Off Start button.
• If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately 5 minutes.
17