Recalling Stored Measurement Values - Panasonic EW3109 Operating Instructions Manual

Recalling Stored Measurement Values
Measurements can be recalled after measurement is completed or after
the power has been switched off.
• If no measurement values are stored, no value will be shown.
1. Press the Memory/Recall button for the person
whose data you want to recall.
The average of all measured values in memory
will be shown.
• GEO will be shown at the top right of the display.
■ For example, if 90 measured values are stored,
the average of the 90 measurements will be
shown. (If only 1 measurement is stored, the ^0
will not be shown.)
2. Press the Memory/Recall button again.
Each time you press the Memory/Recall button,
the previously stored measurement values will be
shown in order, starting with the newest data.
Do not press the Memory/Recall button for an
extended length of time. If you hold the button
pressed for approximately 3 seconds or longer, all
data in memory will be erased, so please be careful.
3. To cancell measurement value recall, press the
On/Off Start button.
• If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately 30 seconds.
18