Storing Blood Pressure Readings; Calling Up Readings From Memory - Panasonic EW3111 Operating Instructions Manual

Storing blood pressure readings

This monitor has enough memory capacity to store 21 readings for
two users.
M1 and M2 will flash on the display
after a measurement.
1. Press the Memory/Recall
Button number if you want
your readings to be recorded.
Example:
Person A is recorded under M1
Person B is recorded under M2
2. Memorization completed
Twenty-one readings can be
recorded for each person. If you
exceed the number of readings,
the existing readings will be
deleted in order of the oldest
as new readings are made.
• Measurements for which
accurate readings could not be
obtained (display of error
symbol E for blood pressure
values) cannot be stored in the
memory.
NOTE: Blood pressure readings can be memorized when the error symbol E is
displayed only for the pulse rate.
When you want to clear all memory
1. To call up the data that you wish to delete, simply push the
Memory/Recall Button number of that user.
2. Push the same user's Memory/Recall Button again, for more than
about 3 seconds, until the memorized readings are deleted
NOTE: Individual readings in the memory cannot be deleted selectively.
13
140
130
90
85
P/min.
M1 M2
M / R M / R
1
140
130
90
85
P/min.
M1
Number of readings in memory

Calling up readings from memory

M / R
1
2
M1
M / R
1
M1
On/Off
Start
Readings may be recalled once they have been
stored in the memory without having to
pressing the ON/OFF/Start Button.
1. Push the Memory/Recall Button number of the user
whose data you want to call up, M1 for example.
‹Averaged values for all recorded measurements
140
are displayed›
130
• M1 A is displayed at the bottom of the screen.
90
• When, for example, 21 readings have been
85
recorded, the average values of 21 readings will
P/min.
be displayed. (When there are no readings or only
one reading in memory, M1 A is not displayed.)
• The blood pressure indicator LED will flash
(approx. 6 seconds)
2. Press the Memory/Recall Button again.
‹Each time the Memory/Recall Button is pressed
readings are displayed in order of the most
recent entry›
• The blood pressure indicator LED will flash
(approx. 6 seconds).
• Nothing will be displayed when there are no
readings in the memory.
140
Please use a quick, light touch when pressing
130
the Memory/Recall Button. Take care to do
90
so, as continuous pressing of the button for
85
a duration of two seconds or more will clear
P/min.
all readings from the memory.
3. Press the ON/OFF/Start Button to turn off the
unit.
• If you should forget to turn off the unit after
calling up the memory without pressing the
ON/OFF/Start Button, the unit will switch off
automatically after approx. 30 seconds.
14