Storing Blood Pressure Readings; Calling Up Readings From Memory - Panasonic EW3003 Operating Instructions Manual

CAUTION:
• For persons with poor circulation resulting from diabetes, liver disease,
arteriosclerosis, high blood pressure or other conditions, there may be
significant differences in blood pressure values measured at the wrist
versus at the upper arm.
• Do not confuse self-monitoring with self-diagnosis.
• NEVER change a prescribed medication without first consulting with
your physician.

Storing blood pressure readings

Fig. 9-a
1. The
been completed (Fig. 9-a).
Press the Memory/Recall button.
2. Memory storage is completed.
• Readings of up to 21 measurements can be stored in
memory (Fig. 9-b). Readings over the memory capacity
will be recorded over the oldest measurement in
memory.
(After approx.
one second.)
• Readings cannot be saved when a measurement has
been unsuccessful (display of the error mark
Fig. 9-b
blood pressure readings). Readings can be saved,
however, when the
rate.
15
mark will flash after a measurement has
mark is displayed for the pulse

Calling up readings from memory

Fig. 10-a Readings can be recalled after being saved without
having to switch the unit on.
1. Press the Memory/Recall button.
(After approx.
one second.)
Fig. 10-b
2. Press the Memory/Recall button to display readings
3. Press the On/Off and Start button to switch off the
for
Deleting all data stored in memory
(1) Recall stored data using the Memory/Recall button.
(2) Press the Memory/Recall button again and hold it (for approx. 3
seconds) until all readings are deleted.
NOTE: Readings from individual measurements cannot be deleted.
(3) When data has been deleted the
displayed on the screen.
• The average readings of all recorded measurements
are displayed.
• The mark will be displayed (Fig. 10-a).
• When, for example, readings from 21 measurements
have been saved the average of the readings from 21
measurements will be displayed.
starting with from the most recent measurement.
• Each time the Memory/Recall button is pressed
readings are displayed in order of the most recent
measurement (Fig. 10-b).
• No readings will be displayed when there are none in
the memory.
unit.
If you forget to switch off the unit it will do so
automatically after approx. 30 seconds.
mark and will be
16