Table of Contents
Advertisement
25
PREPARATIONS BEFORE MEASUREMENT
*Always use alkaline batteries
1 Inserting dry cell batteries.
(1)Remove the battery case by
pushing it in the direction of
the arrow.
(2)Insert the batteries, ensuring
the correct polarity.
Slide the battery case back into
place on the main body until it
clicks into place.
Remove the from its storage case.
Z\CAUTION:
e Always follow the cautions printed on the batteries.
e Check the polarities of the batteries and install them correctly.
e Promptly remove exhausted batteries.
e If the product will not be used for a long time,remove the batteries.
e Batteries should be used before their expiration date.
Use after the expiration date may result in injury or staining of the surrounding
area due to generation of heat,bursting,or leakage.
Replace batteries when:
The mark shown at right appears
during measurement.
e No display is shown when
开始 /结束
button is pressed.
blood pressure
shown in the figure
Wrap the pressure cuff
so that the top of the
unit is aligned with the
base of the wrist
Base of the wrist
Wrap the pressure cuff
so that the positioning
mark will be at the
center of the wrist
POSITIONING THE PRESSURE CUFF
wrist.
eWrap the cuff on bare skin.
Measurable wrist
circumference:12.5 cm to
22.0 cm
1 Attach on the inside of the
Fasten the cuff firmly
2
elf the cuff is wrapped
loosely, the measured
value for blood pressure
will be high.
e Avoid twisting the belt
when fastening.
Do not remove the hook and loop fastener by
twisting it off.
Be sure to peel it in an upward direction in
alignment with the cuff.
When measuring on the right wrist:
The blood pressure monitor can be
used by wrapping the cuff on either
wrist. However, since it has been said
that the difference in blood pressure
between the left and right wrists may
be around 10 mmHg , be sure to
always use the same wrist for
measurements.
Advertisement
Table of Contents
