Assembling Instructions; Assembling The Curved Handle; Installing The Grass Box - Parkside PRMA 20-Li A1 Translation Of The Original Instructions

modifi ed plugs and matching
sockets reduce the risk of elec-
tric shock.
• Avoid body contact with
earthed surfaces such as pipes,
radiators, cookers and refrigera-
tors. There is an increased risk
of electric shock if your body is
earthed.
• Do not expose electric tools to
rain or wet conditions. The pen-
etration of water into an electric
tool increases the risk of electric
shock.
• Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fi re
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for
your battery and charg-
er from the Parkside
X 20 V Team series. A
detailed description of
the charging process
and further information
can be found in the sep-
arate operating instruc-
tions.

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confi dent.
• In case of uncertainty, contact a spe-
cialist or contact our service directly
Assembling the
Curved Handle
Installing lower bars:
1. Slide the two ends of the lower
handle bar (3) into the receptor
on the mower housing.
2. Fasten the lower bar (3) using
the enclosed washers and quick
release levers (2a).
3. Lock the clamping levers (2a)
by pushing them towards the
bar (1). Clamping levers to be
tightened and contacting the bar
such that they clamp at average
force.
Otherwise you may have to
tighten (turn clockwise) or loosen
them (turn anticlockwise).
Installing upper handle:
4. Attach the bow-type handle (1)
to the lower bars (3) with the
enclosed nuts (2b) and quick
release levers (2a).
There are two positions possible.
Mounting cable holder:
5. Clip the cable holder (
into the bar (3) and thus fi x the
cable (
If you release the quick release
levers (2a), you can fold the bow-
type handle (1) downwards to store
the device. Ensure that the power
cable ( 14) is not caught.

Installing the grass box

1. Pull the plastic straps over the linkage
tubes.
2. Insert the handle (4a) of the grass
collection box (4) into the provided re-
GB
13)
14).
IE
27