Parkside PRMA 20-Li A1 Translation Of The Original Instructions page 26

GB IE
- make sure that all nuts, bolts
and screws are properly tight-
ened.
- inspect the apparatus for any
damage.
- have any necessary repairs
carried out to damaged
parts.
• Do not place feet or hands near
or under rotating parts. Do not
stand in front of the grass ejec-
tion hole during sickle mowing.
• Always pull the circuit breaker/
ignition key if:
- you leave the apparatus
unattended, before clearing
blockages,
- if you check or clean the ap-
paratus or work on it,
- after a collision with a for-
eign object. Immediately
examine the device for dam-
age and, if necessary, have
it repaired,
- if the apparatus starts to
vibrate in an unusual way
(check immediately!).
• When starting or turning the
motor on, the lawnmower must
not be tilted, unless it is required
to lift the lawnmower in the
process. In this event, tilt it only
as far as absolutely necessary
and lift it only on the side facing
away from the user.
Maintenance and Storage:
• Allow the motor to cool before
storing the equipment in a con-
fi ned space.
• During maintenance of the cut-
ting blades, be aware of the
fact that even if the power sup-
26
ply is switched off, the cutting
blades can be set into motion.
• Ensure that all nuts, bolts and
screws are tightened fi rmly and
the equipment is in safe working
condition.
• Do not attempt to repair the
equipment yourself unless you
have been trained to do so.
Any work not specifi ed in these
instructions is to be carried out
only by customer service centres
that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass collec-
tion device for wear and strains.
For safety reasons, replace
worn or damaged parts. When
adjusting the blades, take par-
ticular care to avoid fi ngers
being trapped between the ro-
tating blades and fi xed parts of
the machine.
• Check that only replacement
tools authorised by the manufac-
turer are used.
Electrical Safety:
• The plug of the charger must fi t
into the socket. The plug must
not be modifi ed in any way.
Do not use any adapter plugs
together with electric tools that
have a protective earth. Un-