Assembly; Assembling The Curved Handle; Operation; Hanging On/Removing The Grass Bag - Parkside PRM 1800 A1 Manual

GB
IE
injuries, we recommend that persons
with medical implants consult their
doctor and the manufacturer of their
medical implant before operating
the machine.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved
Handle
For a simple holmm installation, select
cutting height 20 mm (see „Adjusting
the cutting height").
1. Remove the two pre-installed
B
butterfly nuts (2a) from the lawn-
mower housing (7). Insert the
lower bar (3) into the slot on the
lawnmower housing (7).
2. Fix the bottom bar (3) using the
two screws and butterfly nuts
(2a).
3. Tighten the loop handle (1) with
C
the enclosed carriage bolts (16)
and two locking levers for beam
attachment with washer (2b) to
the lower beam (3).
4. Clip the cable holders (10) onto
the lower bar (3) and the U-
shaped grip (1) and use them to
fix the appliance's cable in place
(21). The cable holders (10)
should be arranged on the thin
part of the bar.
5. Adjust the angle of the U-shaped
handle (1) by releasing the lo-
cking lever (2b) and choosing
30
one of the three recommended
settings, which are shown next
to the locking lever (see detail
illustration).
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment. En-
sure that the appliance's cable (21) is
not trapped.
Mounting the grass
collection bag
Loop the three tabs (22) over the
D
grass collection bag frame (23)

Operation

Hanging On/Removing the
Grass Bag
1. To hang on the grass bag (4),
D
lift the collision guard (9) and
hang on the grass bag. Fold the
collision guard (9) onto the grass
bag (4). It holds the grass bag in
the correct position.
2. To remove the grass bag (4), lift
the collision guard (9) and detach
the grass bag. Fold the collision
guard (9) back onto the mower
housing.
Do not work with the lawn-
mower without the collision
guard or lawn box. There is
a risk of injury.

Level gauge

E
The level gauge (17) is located on the side
of the grass catcher (4).