Ozito PXNGS-218 Instruction Manual
Ozito PXNGS-218 Instruction Manual

Ozito PXNGS-218 Instruction Manual

18ga brad finishing nailer

Advertisement

6. TROUBLESHOOTING
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
WARNING!
ALWAYS WEAR PROTECTIVE
EQUIPMENT WHEN REMOVING JAMMED NAILS."
Jammed Nail
1. Open the jam release latch to
check for any jammed nails
inside.
2. Open the jam release latch. (1)
Using a pair of pliers, carefully
remove any jammed nails. (2)
(1)
(2)
3. Check for any jammed nails in
the magazine.
WARNING!
THIS JAM RELEASE LATCH SHOULD
'CLICK' SHUT SECURELY BEFORE USE TO PREVENT
ACCIDENTAL MISFIRING.
Short Battery Runtime
Ensure the battery is properly charged. It will take 4-5 charging cycles
before the battery reaches optimum charge and run time.
(1)
(2)
MAINTENANCE
WARNING!
BEFORE CLEANING OR CARRYING OUT
ANY MAINTENANCE PROCEDURE, ENSURE THAT
THE BATTERIES HAVE BEEN REMOVED.
Cleaning
• Keep the ventilation slots of the tool clean at all times to ensure efficient
operation.
• After each use, blow air through the tool housing to ensure it is free from
all dust, dirt, etc. Build up of dust or dirt particles may cause the tool to
overheat and shorten the life of the tool.
• If the housing of the tool requires cleaning, do not use solvents. Use of a
cloth only is recommended.
• Never allow any liquid to get inside the tool, never immerse any part of
the tool into liquid.
Storage
When not in use, the tool should be stored in a dry, frost free location, keep
out of children's reach.
Note: Ozito Industries will not be responsible for any damage or
injuries caused by repair of the tool by an unauthorised person or by
(1)
mishandling.
(2)
DESCRIPTION OF SYMBOLS
V
Volts
Direct Current
Revolutions or reciprocations
/min
per minute
Wear eye & ear protection
Read Instruction Manual
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed
of with household waste but in an environmentally friendly
way. Please recycle where facilities exist. Check with your local
council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
SPARE PARTS
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse.
For further information, or any parts not listed here,
visit www.ozito.com.au or contact Ozito Customer
Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquiries@ozito.com.au
mm
Millimeters
Warning
Regulatory Compliance Mark
(RCM)
Ah
Ampere Hour

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PXNGS-218 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ozito PXNGS-218

  • Page 1 When not in use, the tool should be stored in a dry, frost free location, keep out of children’s reach. Note: Ozito Industries will not be responsible for any damage or 2. Open the jam release latch. (1) injuries caused by repair of the tool by an unauthorised person or by Using a pair of pliers, carefully mishandling.
  • Page 2: Electrical Safety

    Children should be supervised to ensure that they do not play with the appliance. • This appliance is compatible and only to be used with all batteries & chargers from the Ozito PXC range. Refer to the PXC battery and charger manuals for information regarding charging, use and storage.
  • Page 3: Warranty

    • Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. OZITO INDUSTRIES PTY. LTD. 25 Fox Drive, Dandenong South, VIC 3175, Australia. 0323...
  • Page 4: Know Your Product

    1. Hold down the battery release button and then slide the battery out. BATTERY & CHARGER This tool is compatible with all batteries & chargers from the Ozito PXC range. ONLINE MANUAL Scan this QR Code with your mobile device to take you to...
  • Page 5: Nail Selection

    2. NAIL SELECTION 3. LOADING THE CARTRIDGE WARNING! ENSURE THE TOOL IS SWITCHED Seleting Nails OFF AND THE BATTERY IS REMOVED BEFORE Accessories to suit this Staple Nail Gun can be purchased from Bunnings PERFORMING ANY OF THE FOLLOWING TASKS. Warehouse.
  • Page 6: Operation

    2. Turn the dial anti-clockwise to decrease the nail depth. Note: If the nail is not fully penetrating into the workpiece, firmly hold down the nail gun with two hands while firing. PXNGS-218...

Table of Contents