LG OLED77M3 Series Manual page 113

Checking before turning on wireless TV
Clearing obstacles
Placing Zero Connect Box on top of cabinet
Adjusting Zero Connect Box antenna left or right (dial)
Adjusting Zero Connect Box antenna up or down (sliding button)
12
• Remove any obstacles between the TV Screen and Zero Connect Box. If there are obstacles, the
wireless signal is attenuated and causes screen disconnection.
• When using a cabinet, install the Zero Connect Box on top of the cabinet. If installed inside a cabinet,
the screen may disconnect due to interference.
• Voice recognition may also become degraded or not work at all.
Sliding button Dial
• Adjust the dial on the Zero Connect Box left or right until the sliding button faces the wireless
receiver on the TV Screen.
• By adjusting the dial, you can move the direction of the wireless signal transmission of the Zero
Connect Box left or right. You can adjust the dial up to 90˚ left or right from the front LED.
Down Up Highest angle
• Place the Zero Connect Box lower than the TV Screen wireless receiver.
• Adjust the sliding button up or down so that the wireless signal transmission direction of the Zero
Connect Box faces the TV Screen wireless signal receiver.
• If you adjust the sliding button towards the LED (blue line), the antenna transmits in a forward
straight direction. If you adjust it away from the LED (green line), the antenna transmits in an
upward direction. The Zero Connect Box antenna transmits in the 0-50˚ direction.
Lowest angle 50˚