Panasonic NV- MS1 Series Operating Instructions Manual page 22

oe
eTracking Control
TRACKING
When the playback picture contains noise bar distortion as shown
in the picture above, it can be eliminated by pressing the Tracking
Adjust Button.
To return the tracking control to the former setting, press the two
buttons simultaneously.
When playing back a tape which has been recorded on another
video recorder, it may not be possible to completely eliminate this
distortion.
@Noise which takes the form of horizontal bars appears in the Cue,
Review and Still playback modes. This is not an indication of a
malfunction.
elf the S-VHS Movie is left in the Still Playback mode, for more
than about 6 minutes, the S-VHS Movie will switch over to the
stop mode to protect the tape and the video heads.
-22
Tape Counter and Memory Function
Press the Reset Button at a desired point and then press the
Memory Button.
eThe Tape Counter is reset to "0000" and the Memory Indicator
"M" appears.
COUNTER
RESET MEMORY
@ @
Tt ofiy
After pressing the Stop Button to end the playback, press the
Rewind/Review Button.
@The tape will automatically stop at about the point where the Tape
Counter reads "0000".
Counter Indication
By repeatedly pressing the Memory Button, the Counter Indication
can be changed in the following sequence.
Memory appears Lap Time
Tape Counter with Tape Counter Counter Indication
Indication Indication (Real Time) appears —_No indication
0000 —+»| M0000
The indication of the Lap Time Counter counts up only during
recording.