Advertisement
Available languages
Available languages
CONTROLS AND INDICATORS
@
POWER switch
Depress the power switch and the lamp at the center of the
reverberation indicator @ will fight, indicating that the power
is ON. To turn off the power, depress the switch again
@ TAPE monitor switch
ON:
To playback a tape deck connected to the amplifier or
to monitor the sound being recorded
OFF;
To listen to other program sources (FM/AM, turn-
table, microphone,
etc.) connected to the arnplifier.
@ > REVERBERATION switch
This switch turns the reverberation unit ON and OFF.
@
REVERBERATION REC switch
To' add the reverberation
effect on to tape,
set both the
reverberation recording switch and reverberation switch @
to ON
If only the reverberation switch @ is ON, the tape is recorded
without the reverberation effect but the sound being played is
heard with the reverberation effect
@
EFFECT switch
To obtain a normal reverberation effect, set this switch to the
"1" position (OUT}. To obtain a duet effect, set the switch to
je ''2"' position {IN}.
4 RAsom)
@
ATTENUATOR switch
This
switch
is used
to
reduce
the
input
level
to
1/2,
eliminating
any possibility
of distortion
due to high input
signals.
@
Reverberation time control {REVERB TIME}
Adjusts the reverberation time. With the effect switch in the
"'4*" position, the reverberation time is adjustable from O to
2.5 sec., and in the ''2" position, frorm 30 to 100 msec.
@ DEPTH contro!
Adjusts the amount
of reverberation.
Turning
the control
clockwise will emphasize the reverberation
© Reverberation indicator
This is used to visually check the reverberation effect. The
lights of the indicator lamps will spread to left and right accor-
ding to the strength ot reverberation
Advertisement
