Toyostove Laser 30 Type B Installation And Operation Instructions Manual page 26

Laser clean heating system/vented heater

Hide thumbs Also See for Laser 30 Type B:

Table of Contents

Secure the L-shaped hose to the intake inlet mouth with the hose band. Secure the bent joint to the

standard flue pipe with the pipe holder (If the extension pipe is used, also attach the pipe holder to the

connection of the bent joint and the extension pipe). Secure the bent joint (or the extension pipe) to the

exhaust outlet mouth by sliding the pipe stopper into the exhaust mouth bracket (See Fig. 12).

Pipe Stopper

Make sure the position of the heater is level by using the plumb bob located at the right side of the

heater. The plumb bob weight should be within the circle. If the plumb bob weight is not within the cir-

cle, adjust the heater legs until the plumb bob weight is within the red circle (See Fig. 13 & 14).

Plumb bob as viewed from above

Fig. 12

Good

Weight

Circle

Bad

Fig. 13

Pipe Holder

Pipe Stopper

Fig. 14

Table of Contents

Show Quick Links

Table of Contents

Toyostove laser 30 type d Laser 30