Explanation Of Functions; Program Sensor; Establish Programming Mode; Programming The Centronicplus Sensor - Becker CentronicPLUS SC811A PLUS Assembly And Operating Instructions Manual

The sensor continually transmits the current measured sensor values. The reaction to
the thresholds set in the receiver being exceeded or not met depends on the receiver
being used and on the particular settings on this receiver.
Indicator lamp
The indicator lamp provides visual feedback such as radio transmissions. Once the
power supply has been switched on and while the device is starting up, this lamp will
briefly light up green.
Function/control button
This button is for adjusting the settings. In normal mode, the drive commands are ex-
ecuted in the following order RETRACT - STOP - EXTEND - STOP, etc.

Establish programming mode

This step is only necessary if one of the devices to be pro-
grammed is not yet part of the installation. This is the case
for brand new products, for example, or devices from an-
other installation or products that have been restored to
factory settings.
Please find the appropriate description in the instructions for the receiver.

Programming the CentronicPLUS sensor

There are multiple ways to program the sensor:
• With the programming button on the sensor
• With an SWCxxxPLUS transmitter
With the programming button on the sensor
With brand new products, devices from another installa-
tion or products that have been restored to factory set-
tings, programming mode must be established before-
hand (see Establishing programming mode).

Explanation of functions

Program sensor

7 - en