Reserve Lan Ip Addresses - TP-Link TL-MR105 User Manual

Chapter 11
4 Specify the IP Address
same subnet with LAN IP. The router will assign addresses within this specified
range to its clients. It is from 192.168.1.100 to 192.168.1.199 by default.
5 Enter a value for the
of time in which a DHCP client can lease its current dynamic IP address assigned
by the router. After the dynamic IP address expires, the user will be automatically
assigned a new dynamic IP address. The default is 1440 minutes.
6 Keep the rest of the settings as default and click
Note:
1. The router can be configured to work as a
between computers that request IP addresses and the DHCP server that assigns the addresses. Each of the device's
interfaces can be configured as a DHCP relay. If it is enabled, the DHCP requests from local PCs will be forwarded to
the DHCP server that runs on WAN side.
2. You can also appoint IP addresses within a specified range to devices of the same type by using
feature. For example, you can assign IP addresses within the range (192.168.1.50 to192.168.1.80) to Camera devices,
thus facilitating the network management. Enable DHCP feature and configure the parameters according to your
actual situation on Advanced
11 4 3

Reserve LAN IP Addresses

You can view and add a reserved address for a client. When you specify an IP address
for a device on the LAN, that device will always receive the same IP address each time
when it accesses the DHCP server. If there are some devices in the LAN that require
permanent IP addresses, please configure Address Reservation on the router for the
purpose.
Follow the steps below to reserve an IP address for your device.
1 Visit http://tplinkmodem.net, and log in with your TP-Link ID or the password you
set for the router.
2 Go to Advanced
3 Scroll down to locate the
reservation entry for your device.
Pool, the start address and end address must be on the
Address Lease Time. The
DHCP Relay. A DHCP relay is a computer that forwards DHCP data
> Network > LAN Settings
> Network > LAN Settings
Address Reservation
Specify Your Network Settings
Address Lease Time
Save to make the settings effective.
page.
page.
table and click
is the amount
Condition Pool
Add to add an address
52