Troubleshooting; Common Faults - Espressione ESP-2016 Instruction Booklet

Flex 3-in-1 stainless steel espresso coffee machine
Table of Contents

Advertisement

Available languages

Available languages

Troubleshooting

Common Faults

Fault
Coffee is
spilling out
from the gap of
the funnel.
Coffee handle
cannot be
pushed into the
lock position.
Coffee is cold.
Instruction Booklet
Possible Cause
There is debris inside the
seal ring.
The coffee grounds are
too fine.
The coffee grounds have
been pressed too tightly.
The seal ring is wearing
out.
There are coffee grounds
at the top of the filter
cup.
The amount of coffee
grounds in the funnel has
exceeded max.
No coffee has been
added to the funnel, and
the handle cannot be
pushed to the lock
position.
The indicator light is not
on.
The coffee machine was
not preheated.
The coffee cup was not
preheated.
24 of 85
Solution
Clean the debris from inside
the seal ring.
Replace coffee grounds with
a relatively coarser ground.
Replace the coffee grounds
and press again, with about
8 pounds (3.6kg) of
strength.
Please contact the
authorized ESPRESSIONE
Service Center.
Clean the top of filter cup
before putting it into the
machine.
Decrease the amount of the
coffee powder.
Please contact the
authorized ESPRESSIONE
Service Center.
Operate the machine only
when the indicator light is
on.
Preheat the coffee machine.
Preheat the coffee cup.
ESP-2016

Advertisement

Table of Contents
loading

Table of Contents