Troubleshooting - Espressione Cafe Roma De Luxe Instructions Manual

EN
PROBLEMS
The coffee maker does not
supply boiling water for
tisanes
The coffee maker does not
supply steam.
Coffee overflowing from
the edges of the filter ring
The coffee is not supplied
or flows too slowly.
The coffee is too watery
and cold.

TROUBLESHOOTING

CAUSE
Air has probably entered the
circuit and deactivated the
pump.
There is little water and the
pump does not suck it up.
The steam exit hole on the
dispenser wand is clogged.
Probably an excess amount
of ground coffee has been
placed in the filter ring
preventing the filter ring from
being correctly tightened into
its housing.
The outlet hole of the filter
containing the grounds is
obstructed.
It is possible that the scarce
outflow of coffee also depends
on the insufficient emission
of water from the perforated
showerhead type disc in the
filter ring housing. In fact it
is possible that after a few
months of use, fat or lime
residues can obstruct the disc.
The tanks is not inserted
well. Fit the tank securely by
pushing it as far as it will go.
There is little water and the
pump does not suck it up. Fill
the tank.
The coffee blend is ground too
fine, or excessively tampered.
The blend has been ground
too coarsely.
SOLUTIONS
Make sure the tank is properly inserted and
that the water is not below the minimum level.
Repeat the operations described in the
"Preliminary phases for use" paragraph.
Use a pin to unclog the wand.
Make sure the water level in the tank is
normal.
Repeat the operation placing the correct
quantity of coffee in the filter.
Residues of coffee grounds have remained
on the seal.
Clean the seal with a toothpick or a sponge.
If the problem persists after carrying out
the above operations, go to an Authorized
Assistance Center.
Clean the obstructed hole of the filter with a
pin.
Check the filter containing the ground
coffee. If the holes are blocked they should
be cleaned using a small brush or using a
suitable tool. Let boiling water run through
the filter holder to dissolve or remove any
possible residue of coffee or impurity.
Operate the machine without the filter ring,
allowing the water to flow.
If water is still not flowing uniformly through
each hole, please contact your nearest
Authorised Service Centre to have your
appliance cleaned.
Try using coarser coffee blends. Tamper
coffee inside the filter using less pressure.
A more finely ground blend must be used to
obtain a more concentrated and hotter coffee.
Anyhow, this problem is easily solved thanks
to the Thermocream® system, which always
guarantees hot coffee accompanied by a
reach cream, even with coarsely ground
beans.