Bosch AdvancedDistance 50C Original Instructions Manual page 33

All stored values are retained when the tool is switched off.
Measuring Process
Once switched on, the measuring tool is in the length measure-
ment function.
Once the measuring tool has been switched on, the rear edge
of the measuring tool is selected as the reference level for
measurement. You can change the reference level. (see "Se-
lecting the Reference Level", page 34)
Apply the measuring tool to the point at which you want to
start the measurement (e.g. wall).
Press the
Target the target surface with the laser beam.
Briefly press the
ment.
In the continuous measurement function, the measurement
begins immediately after the first press of the
For more information, you can access the online op-
erating instructions at www.bosch-pt.com/manuals
The measuring tool must not be moved during a meas-
urement (with the exception of the continuous meas-
urement and grade measurement functions). Therefore, place
the measuring tool, as far as this is possible, against or on a
firm stop or supporting surface.
The reception lens (9) and the laser beam output (8)
must not be covered during the measuring process.
Bosch Power Tools
button to switch on the laser beam.
button again to start the measure-
1 609 92A 85V | (14.03.2023)
English | 33
button.