Cable Connections - LG RESU3.3 Installation Manual

NOTE
To prevent the circuit board from being damaged or soiled, keep it in a safe place until it
is replaced.
5.4

Cable connections

WARNING
Before connecting cables to the RESU Plus, make sure that the inverter and battery packs
are turned off.
3. Pull up the circuit board to remove it.
4. Determine where the anchor bolts are to be
placed.
5. Drill holes in the wall for the M8 (0.3 in)
anchor bolts. The drilling depth should be 50
mm at least.
6. Drive the anchor bolts into the wall holes
through the screw holes at the upper left and
the lower right of the rear of the RESU Plus.
7. Tighten the anchor bolts to a torque of 8 N·m.
RESU Plus Installation
35