Table of Contents
Advertisement
Condition/Problem
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Pedals loose/unit difficult
to operate
Drive train click/tick
noise once per full crank
revolution
Knocking sound during
machine operation
Squeaking noise
that appears a few
minutes into a workout
and normally will get
progressively worse as
the workout continues
Console continuously
cycles through program
screens
Things to Check
Check electrical (wall)
outlet
Check connection at front
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
(requires shroud removal)
Check leveler adjustment
Check surface under unit
Hardware
Check crank/pulley
assembly
Check Pedal, Leg and
Handlebar assemblies
Check for loose hardware
Check hardware at
junction between Lower
Handlebar Arm and Pedal
Bolts that connect the
Lower Handlebars to the
axle running through the
Main Assembly
Roller squeaking on rail
Console is in demonstra-
tion mode
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace cord
or power inlet if either are damaged.
All wires in the cable should be intact. If any are cut or pinched,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Adjust levelers until machine is level.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Tightly secure all hardware on the Pedals, Legs and Handlebar
Arms.
Disconnect left and right foot assemblies and rotate crank. If
sound persists, replace crank/pulley assembly. If sound does
not come from rotating crank, check foot assemblies and up-
per/lower handlebars.
Manually move Pedal, Leg, and Handlebar assemblies to iso-
late sound. Replace part making sound.
Tightly secure all hardware on the Rail Assembly and the base
of the Console Mast.
Make sure that the alignment tab on the Pivot Sleeve goes into
the slot in the hole. Be sure the Pivot Sleeve extends through
the opposite hole in the joint cover.
Loosen pivot rod bolts slightly until noise goes away. White
lithium grease can also be applied for a temporary fix. Contact
Customer Service (if inside US/Canada) or your local distribu-
tor (if outside US/Canada).
Apply silicone lubricant to a dry cloth and wipe the rails to
eliminate roller noise.
Press and hold the Schwinn
setting will take effect after the next time the machine goes into
Sleep Mode.
Solution
logo button for 3 seconds. The
™
49
Advertisement
Table of Contents
