Version Info; Auto Power Off - Toshiba PDR-2300 Owner's Manual

Changing the System Settings (Setup Mode) (continued)
[NTSC]
[PAL]

VERSION INFO.

This option displays the firmware version. "Firmware" refers to the software that controls the camera's
operation. The firmware is pre-installed in the camera.

AUTO POWER OFF

In case no operation is carried out for a certain period of time while powered on, the camera stays idle or
turns off automatically to conserve power after the inactivity period as mentioned below.
To activate the camera again while stayed idle, press any button or switch the mode dial.
If the camera is shut off automatically, you need to turn the camera on again by sliding the [ POWER ]
switch. The table above shows the default settings of auto power off. You can change the setting by using
the [
[3 min], [5 min], [10 min], [30 min]
NOTE
The camera will remain the auto power off setting even if it is turned off.
86
: select this format when located in the U.S.A., Canada, Japan, Korea, Taiwan, Central
America, Mexico, etc.
: select this format when located in Australia, Austria, Belgium, China, Denmark, Finland,
Germany, Great Britain, Holland, Italy, Kuwait, Malaysia, New Zealand, Singapore, Spain,
Sweden, Switzerland, Thailand, Norway, etc.
Inactivity Period
90 seconds
3 minutes (default)
/ ] button and then press the [OK] button.
Camera Status
stay idle
shut off