iSolution COLOR BAR 12TC User Manual page 11

want an instant show.
2-light show
In slave mode, slave 1 means the unit run as the master unit and slave 2 means 2-light show.
In order to create a great light show, you can set slave 2 on the second unit to get contrast
movement to each other, even if you have two units only.
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to
the 1/4" microphone jack of the first unit, you will find that the remote controller
on the first unit will control all the other units for Stand by, Function and Mode
selection
Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Mode Sound (LED OFF)
4.3 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the DMX Address is showing on the display. Press
ENTER button and the display will blink. Use DOWN and UP button to change the DMX512
address. Once the address has been selected, press and keep ENTER button to store. To
go back to the functions without any change press the MENU button or wait for 1 minute to
exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units:
Channel Mode
3 channels
6 channels
9 channels
12 channels
Select
Manua Color
or color 1-32
LED On
Unit 1 Unit 2
1 4
1 7
1 10
1 13
11-
Select Select Speed
show 1-8 1. Slow
or Auto fade 2. middle
3. Fast
Slow blinking Fast blinking
Unit 3 Unit 4
7 10
13 19
19 28
25 37