Draining Remaining Water And Cleaning The Pump Filter - Beko WKY 71033 PTLYW2 User Manual

1 Close the taps.
2 Remove the nuts of the water intake hoses to
access the filters on the water intake valves.
Clean them with an appropriate brush. If the
filters are too dirty, take them out by means of
pliers and clean them.
3 Take out the filters on the flat ends of the water
intake hoses together with the gaskets and
clean thoroughly under running water.
4 Replace the gaskets and filters carefully in their
places and tighten the hose nuts by hand.
5.5 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
washing water. Thus, the water will be discharged
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house) and in case
of freezing of the water, water may have to be
drained completely.
WARNING:
Foreign substances left in the
A
pump filter may damage your machine or
may cause noise problem.
WARNING:
If the product is not in use, turn
the tap off, detach the supply hose and
drain the water inside the machine against
any freezing possibility in the region of
installation.
WARNING:
After each use close the supply
hose tap of the product.
In order to clean the dirty filter and discharge the
water:
1 Unplug the machine to cut off the supply
power.
WARNING:
A
Temperature of the water
inside the machine may rise up to 90 ºC. To
avoid burning risk, clean the filter after the
water in the machine cools down.
2 Open the filter cap.
3 Some of our products have emergency
draining hose and some does not have. Follow
the steps below to discharge the water.
61 / EN
Discharging the water when the product has an
emergency draining hose:
a Pull the emergency draining hose out from its
seat
b Place a large container at the end of the hose.
Drain the water into the container by pulling
out the plug at the end of the hose. When the
container is full, block the inlet of the hose
by replacing the plug. After the container is
emptied, repeat the above procedure to drain
the water in the machine completely.
c When draining of water is finished, close the
end by the plug again and fix the hose in its
place.
d Turn the pump filter to take it out.
Discharging the water when the product does not
have an emergency draining hose:
a Place a large container in front of the filter to
catch water from the filter.
b Loosen pump filter (anticlockwise) until water
starts to flow. Fill the flowing water into the
container you have placed in front of the filter.
Always keep a piece of cloth handy to absorb
any spilled water.
c When the water inside the machine is finished,
take out the filter completely by turning it.
4 Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
5 Install the filter.
6 If the filter cap is composed of two pieces,
close the filter cap by pressing on the tab. If it
is one piece, seat the tabs in the lower part into
their places first, and then press the upper part
to close.
Washing Machine / User's Manual