Installation - Beko WKY 71033 PTLYW2 User Manual

2 Installation

Refer to the nearest Authorised Service Agent for
installation of the product. To make the product
ready for use, review the information in the
user manual and make sure that the electricity,
tap water supply and water drainage systems
are appropriate before calling the Authorized
Service Agent. If they are not, call a qualified
technician and plumber to have any necessary
arrangements carried out.
Preparation of the location and electrical,
C
tap water and waste water installations at
the place of installation is under customer's
responsibility.
Make sure that the water inlet and discharge
hoses as well as the power cable are not
folded, pinched or crushed while pushing
the product into its place after installation or
cleaning procedures.
WARNING:
Installation and electrical
B
connections of the product must be carried
out by the Authorized Service Agent.
Manufacturer shall not be held liable for
damages that may arise from procedures
carried out by unauthorized persons.
WARNING:
Prior to installation, visually check
A
if the product has any defects on it. If so, do
not have it installed. Damaged products cause
risks for your safety.
2.1 Appropriate installation location
• Place the machine on a rigid floor. Do not place
it on a long pile rug or similar surfaces.
• Total weight of the washing machine and the
dryer -with full load- when they are placed
on top of each other reaches to approx. 180
kilograms. Place the product on a solid and flat
floor that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the
edges of other furniture.
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the
packaging reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
50 / EN
2.3 Removing the transportation locks
WARNING:
A Do not remove the
transportation locks before taking out the
packaging reinforcement.
WARNING:
Remove the transportation
safety bolts before operating the washing
machine! Otherwise, the product will be
damaged.
1. Loosen all the bolts with a suitable spanner until
they rotate freely (C) .
2. Remove transportation safety bolts by turning
them gently.
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel. (P)
Keep the transportation safety bolts in a safe
C
place to reuse when the washing machine
needs to be moved again in the future.
Never move the product without the
transportation safety bolts properly fixed in
place!
2.4 Connecting water supply
The water supply pressure required to run the
C
product is between 1 to 10 bars (0.1 – 1 MPa).
It is necessary to have 10 – 80 liters of water
flowing from the fully open tap in one minute
to have your machine run smoothly. Attach a
pressure reducing valve if water pressure is
higher.
If you are going to use the double water-inlet
product as a single
you must install the supplied stopper to the
hot water valve before operating the product.
(Applies for the products supplied with a blind
stopper group.)
WARNING:
Models with a single water inlet
A
should not be connected to the hot water tap.
In such a case the laundry will get damaged or
the product will switch to protection mode and
will not operate.
WARNING:
Do not use old or used water inlet
hoses on the new product. It may cause stains
on your laundry.
1. Connect the special hoses supplied with the
product to the water inlets on the product. Red
hose (left) (max. 90 ºC) is for hot water inlet, blue
Washing Machine / User's Manual
(cold)
water-inlet unit,