Table of Contents
Advertisement
LAN wired connection
1.
If your wireless signal is weak due to a complex environment, (too many obstructions
etc.) you can connect the secondary node(s) through LAN (local area network) wired
connection.
2.
Power off your modem and remove its battery (if any).
3.
Connect an ethernet cable (not included) to a LAN port on the primary node.
4.
Connect the other end of the ethernet cable to a LAN port on the secondary node.
5.
Reinstall its battery and power on your modem.
6.
Use the included power adapter to connect the secondary node to a power source,
the LED indicator turns solid purple. After approximately 40 seconds the LED indicator
should turn solid blue.
Modem
Internet
Touch-link Technology (Guest network)
• At the top of the mesh device there is the Touch-link pad. Touch the pad with your
hand, the sensing pad will flash blue, indicating that Touch-link is in active.
• On your device, search for the wireless network named "MeshGo_Touch" and connect
to it. Note: You will not require a password to join this network.
Primary Node
Router
Secondary Node
Advertisement
Table of Contents
