Kogan KAMESHWFI6A User Manual page 42

FAQ
Q1: How can I remove a node from my Wi-Fi network?
A1: Tap the node on the Kogan Mesh App, tap ... in the upper-left corner and choose Delete.
Note:
Removing operation restores the node to factory settings.
Q2: Can I add another new set of nodes to expand my network coverage?
A2: Yes. Run the Kogan Mesh App, tap Settings, tap Add Kogan Mesh and follow the on-
screen instructions.
Q3: How to restore my network to factory settings?
A3: With your nodes powered on, hold the Reset button of your primary node down using a
sharp item (such as a pin) for about 6 seconds and release it when the LED indicator blinks
fast. Your network is reset successfully when the LED indicator lights solid green then blinks
slow again. All nodes will be restored to factory settings.
Q4. My 2.4 GHz Wi-Fi-enabled devices, such as a home security camera, cannot connect
to my Wi-Fi network. What should I do?
A4: Please try the following solution:
Step 1: Connect your smart phone used during setup to your Wi-Fi network.
Step 2: Run the Kogan Mesh App, tap Settings, Smart Assistant and Enable.
Your smart phone will connect to the 2.4 GHz Wi-Fi network.
Step 3: Use the smart phone to set up your 2.4 GHz Wi-Fi-enabled device following the
prompts in the app.