Maintenance - Siemens VZ67191 Instructions For Use Manual

en
Please fold out the picture page!
Starting up
Illustration 1
a)Fit the turbo brush onto the suction pipe.
b)Push the telescopic pipe into the
supports of the turbo brush until it
audibly engages. Press the unlocking
sleeve and pull out the telescopic pipe to
remove it.
(Equipment will vary with each model).
Vacuuming with the brush
!
Please observe!
Only vacuum using the brush on full
suction power, i.e. max. performance of
the vacuum cleaner.
Illustration 2
If the turbo brush is vacuuming too
strongly, i.e. the slide force is too high,
you can change the slide force by setting
the suction power position, thus
enabling an optimum cleaning effect for
the different floor coverings.
=> long pile carpets
=> short pile carpets
Illustration 3
Only brush the fringes in the direction of
the arrow.

Maintenance

Always switch off the vacuum cleaner and
pull out the plug before performing any
maintenance work. Remove the turbo
brush from the suction / telescopic pipe.
Illustration 4
Cut off any wrapped around hair or
threads using a pair of scissors.
Illustration 5
Then vacuum up the threads and hair
using the corner nozzle.
Subject to technical change without
notice.
5