Advertisement
Remove cap then using a syphon, re-
move gasoline from tank. Using a piece
of rigid wire pull out the pick-up lines
from the gas tank. Itrhouqh filler neck)
and replace the fuel filters.
•
WARNING: Gasoline is flamma-
ble and explosive under certain
conditions. Always perform proce-
dures in a well ventilated area. Do not
smoke or allow open flames or sparks
in the vicinity.
The carburetors must be dried out
completely to prevent gum formation
during the storage period.
Assure that inlet fuel line is discon-
nected.
Remove plug of the float chamber of
each carburetor. Drain carburetors.
Reinstall plug and connect fuel line.
Engine internal parts must be lubrica-
ted to protect cylinder walls from pos-
sible rust formation during the storage
~eriod.
O
NOTE: This operation should be
repeated every 40 days during
storage.
Remove spark plugs. Operate rewind
starter to bring piston at top position.
Pour the equivalent of one spoonful of
oil into spark plug hole.
Slowly crank engine several times
using manual starter. Repeat above
steps for other cylinder. Install spark
plugs.
_
CAUTION: To prevent ignition
"
system damage, make sure that
the cut-out button is in the lower posi-
tion.
Drain the cooling system by discon-
necting the hose from the engine head
elbow, then block off the elbow and
remove the radiator cap from the tank.
Once the system has been drained un-
block the elbow.
~------_._----_
.
. - '
21
Advertisement
