Advertisement
2. Open the driven pulley by twisting
and pushing the sliding half. Hold in
fully open position.
-o----~
3. Slip slackened belt over the top ed-
ge of the sliding half.
~
•
WARNING: Never start or run
engine without drive belt in-
stalled. Running an unloaded engine is
dangerous.
1.
Tilt cab and pulley guard, unlock
and raise driven pulley support.
Routine maintenance is necessary for
all mechanized
products, and the
snowmobile is no exception. A weekly
vehicle inspection contributes to the
life span of the snowmobile as well as
retain safe and trouble-free operation.
It is recommended that the steering
system and suspension, be lubricated
monthly or every
40
hours of opera-
tion. If the vehicle is operated in wet
snow or in severe conditions these
items should be lubricated more fre-
quently .
•
WARNING: Only perform such
procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components / systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for all lubrication and maintenance
procedures.
•
WARNING: Engine should be
running only when pulley guards
are secured in place.
Tilt cab. To tilt drive pulley guard re-
move clip and unscrew wing nut (A).
If necessary to remove driven pulley
guard remove nuts
(8)
and (C).
4. Slip the belt out from the drive pul-
ley and remove completely from
vehicle. To install drive belt, reverse
procedure.
10
Advertisement
