Advertisement
1. Insert key in ignition and turn to ON
2. Test throttle control
lever.
3. Activate primer (2 to 3 times). Prim-
er is not necessary when engine is
warm.
4, Make sure the tether
cut-out
cap is
in position and that the cord is at-
tached to your body. Check that the
emergency cut-out button is in the
released upper position.
5. Grasp manual starter handle firmly
and pull slowly until a resistance is
felt then pull vigorously, Slowly re-
lease rewind starter handle .
..&.
WARNING: Do not apply throttle
. . . while starting.
6. Check operation of the emergency
cut-out
switch/
and
the
tether
switch. Restart engine .
..&.
WARNING: If engine does
not
. . . shut-off when applying the
emer-
gency cut-out switch
and / or
when
pulling the
tether
cut-out cap, stop the
engine
by
turning off the ignition key.
Do
not
operate
the
vehicle further,
see
your
dealer.
7. Allow the engine to warm before
operating at full throttle,
. . CAUTION: Since engine cooling
... is
in effect only when the
vehicle
is in motion,
it
is recommended
that
you do not allow the engine to idle for
more
than
brief
periods. Prolonged
idling may cause
engine
damage.
9
Advertisement
