Advertisement
~
Activate the throttle control lever
several times to check that it oper-
ates easily and
smoothly.
The
throttle control lever must return to
idle position when released.
~
Check that the skis and the track are
not frozen
to the ground or snow
surface and that the steering oper-
ates freely.
~
Activate the brake control lever and
make sure the brake fully applies be-
fore the brake control lever touches
the handlebar grip.
~
Check coolant level. Liquid should
be 2.5 cm (1") below filler neck. If
additional coolant is necessary, al-
ways use a 50 /50 (50 parts of water
for 50 parts of antifreeze) solution.
When entire system has to be re-
filled, use a solution of 3 parts of
anti-freeze for 2 parts of water. See
cooling system in storage .
•
WARNING: Before removing the
cap always release the pressure
by placing a rag on the cap and by par-
tially unscrewing it (first step). If this
is disregarded loss of fluid and possi-
bility of severe burns could occur.
~
Check fuel level
~
Verify that the path ahead of the ve-
hicle is clear of by standers and
obstacles .
•
WARNING: Only start your
snowmobile once all components
are checked and functioning properly.
8
_
CAUTION: Never use sharp tools
.". such as an ice pick, screwdriver
etc.,
to clean the rear end of the vehi-
cle. The use of such a tool will damage
the hose and severe engine damage
will occur.
Advertisement
