Necessary Tools And Instrument List For Installation; Transportation And Handling; Transportation; Handling Of Indoor Unit - Hitachi airCore 700 Operation Installation Maintenance Manual

2.2 Necessary Tools and Instrument List for Installation

No. Tool
1 Handsaw
2 Phillips Screwdriver
3 Vacuum Pump
4 Refrigerant Gas Hose
5 Megohmmeter
6 Copper Pipe Bender
Manual Water Pump
7
(for Indoor Unit)
NOTE:
•
About vacuum pump, gas hose, charging cylinder, gauge manifold, please use suitable equipments
for R32 respectively. Do not mix other refrigerant.

3. Transportation and Handling

3.1 Transportation

Transport the product as close to the installation location as possible before unpacking.
WARNING
!
•
The maximum number of pieces of equipment or the configuration of the equipment permitted to be
transported together will be determined by the applicable local transport regulations.
CAUTION
!
•
Do not put any material on the product.

3.2 Handling of Indoor Unit

WARNING
!
•
Do not put any foreign material into the indoor unit and check to ensure that none exists in the indoor
unit before the installation and test run. Otherwise, a fire or failure, etc. may occur.
CAUTION
!
•
Be careful not to damage on insulation materials of unit's surface when lifting.
No. Tool
8 Plier
9 Pipe Cutter
10 Brazing Kit
11 Hexagon Wrench
12 Spanner
13 Weigher
14 Charging Cylinder
15 Gauge Manifold
-4-
3. Transportation and Handling
No. Tool
16 Cutter for Wires
17 Gas Leak Detector
18 Leveler
19 Clamper for Solderless Terminals
20 Hoist (for Indoor Unit)
21 Ammeter
22 Voltage Meter
23 Wrench