10、 Pc Configuration Instructions - Ebyte E90-DTU User Manual

Hide thumbs Also See for E90-DTU:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

10、 PC Configuration Instructions

The figure below shows the display interface of the E90-DTU SL configuration host computer. The user can switch to the



command mode through M0M1, and quickly configure and read parameters on the host computer.

In the configuration host computer, the module address, frequency channel, network ID, and key are all in decimal display mode,



and the value range of each parameter is:

website address: 0～65535

Frequency channel: 0～83

Network ID: 0～255

key: 0～65535

When using the host computer to configure the relay mode, the user needs to pay special attention. Since the parameters in the



host computer are in decimal display mode, the module address and network ID need to be converted when filling in. For

example, if the network ID input by transmitter A is 02, and the network ID input by receiver B is 10, then when the relay

terminal R sets the module address, convert the hexadecimal value 0X020A to the decimal value 522 and fill it in as the relay

terminal R module address. That is, the module address value that needs to be filled in at the relay terminal R at this time is 522.

E90-DTU(400SL33) User Manual

Table of Contents

400sl33