Chengdu Ebyte Electronic Technology Co., Ltd.
Chapter 4 Function Introduction
4.1 DIP configuration instructions
Icon
MODE 1
MODE 2
MODE 3
Note: The external Modbus slave station needs to avoid the address used by the radio to avoid the communication
bus address conflict:
4.1.1 Configuration mode
M0 (that is, dial code 2) is dialed and the device is in configuration mode, the device uses a fixed baud rate
(9600-8N1), a fixed Modbus address (01H), or the Modbus address configured by the device (uncheck
"Configuration Mode" , and enter the current device address in the "host address" input box, otherwise use a fixed
address to access the device), the wireless transmission in the configuration mode enters the dormant state, and
wireless transmission and reception cannot be performed.
Copyright ©2012–2021, Chengdu Ebyte Electronic Technology Co., Ltd.
M0 (Dial 2)
M1 (Dial 1)
Up
Down
Up
Up
Down
X(Random)
E90-DTU(400SL30L)_UserManual_EN
Mode
Host Mode (WOR
Transmitter)
Slave Mode (WOR Receiver)
Configuration Mode
12