Programming The Water Softener - Kenmore 625.385200 Use & Care Manual

Programming the Water Softener

RECHARGE
button
SET SALT LEVEL
button
STATUS LIGHT
When the Kenmore Elite
connected to electrical power, the status light on the
control panel will be on or flashing, as follows:
Status light flashing rapidly, with "PRESENT
=
TIME" shown in the display and the clock flash-
ing slowly - The present time needs to be set,
either during initial start up or after a long power
outage. See "Set Present Time of Day", at right.
Status light flashing slowly, along with the salt
=
level indicators in the display - The salt monitor
system indicates a low salt level and needs to be
set. See "Salt Monitor System" on Page 15.
Status light flashing rapidly, with "Err" shown
=
in the display - The electronic self-diagnostics
have detected a problem. See "Troubleshooting"
on Page 21.
Status light on steady (not flashing) - The sys-
=
tem has power applied and does not require any
attention.
Display
hybrid water softener is
®
SELECT
button
WATER USE
STATUS light
button
(see below)
PROGRAM THE SOFTENER
When the power supply is plugged into the electrical
outlet, the model code (520P) and a software version
number (example: J3.9), are briefly shown in the dis-
play. Then the words "PRESENT TIME" appear and
12:00 PM begins to flash.
SET PRESENT TIME OF DAY
If the words "PRESENT TIME" do not show in the dis-
play, press the SELECT button a few times until they
do.
r
1. Press the UP or
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
13
UP
button
DOWN
button
FIG. 16
FIG. 17
FIG. 18
s
DOWN buttons to set the
continued on next page