Base Unit (Bu-K6Bd94Dc); Optical Pick-Up Block (Ksm-213Dcp) - Sony HCD-G2BNiP Service Manual

2-15. BASE UNIT (BU-K6BD94DC)

1 two floating screws
(PTPWHM2.6)
2 two cone springs
Note: When you install the cone
spring, adjust sharp side to
the floating screw side.
4 insulator

2-16. OPTICAL PICK-UP BLOCK (KSM-213DCP)

Note 1: When disconnection the wire (fl at type) (16 core) of OP base assy, solder the short-land.
5 optical pick-up block
(KSM-213DCP)
4 BD94DC board
1 Remove four solders.
1 floating screw
(PTPWHM2.6)
4 insulator
– CD mechanism bottom view –
4 insulator
3
2 Solder the short-land.
Note 2: When assembling the optical pick-up block,
remove the solder of short-land after
connecting the wire (flat type) (16 core).
3 wire (flat type) (16 core)
(OP base assy)
HCD-G2BNiP/G2NiP
1 two floating screws
(PTPWHM2.6)
2 two cone springs
Note: When you install the cone
spring, adjust sharp side to
the floating screw side.
4 insulator
5 base unit
(BU-K6BD94DC)
loading (BK) assy
21