10 System Settings
10.1 User Management
HTTP API Authorization can be added and removed, user passwords can be changed, and
notification support can be enabled. if HTTP API Authorization is turned off,
authentication will not be required for API calls, which may lead to security issues!
10.2 Device Reboot
"
" is used for device software reboot, which is equivalent to rebooting the device
and lasts about 1 minute.
10.3 Restore factory settings
If the user modifies parameters that cause the device to not work properly (most typically,
the network address is modified so that the device cannot be accessed over the network),
the factory settings of the device can be restored so that the device's configuration returns
to the factory defaults.
There are two ways to restore factory settings:
① "System Settings" in WEB interface > Restore factory settings;
② LCD display: Enter the second page of the LCD device status by confirming
Copyright © 2023 Kiloview Electronic Technology Co., Ltd.
N6/N5 for NDI·User Manuel
36