Chapter 5: Using The Tv's Features; Selecting The Video Input Source To View; Tuning Channels - Toshiba 20DL77 Owner's Manual

Selecting the video input source to
view
Repeatedly press INPUT on the remote control
or on the TV control panel to view a signal
from another device connected to your TV,
such as a VCR or DVD player. You can select
Video1/S-Video, Video2/ColorStream, PC or
Antenna/Cable channel, depending on which
input jacks you used to connect your devices
☞
( Chapter 2).
To select the video input source using the
program list:
1
Press and hold INPUT or press OK to display
the program list.
OK:
9
7
2
PC
Video2
Video1
99
98
2
To scroll through the program list, repeatedly
press s or t while the program list is on-
screen.
To view signal connected to Video-1 IN,
select Video1/S-Video.
To view signal connected to Video-2 IN,
select Video2/ColorStream. (Component
video input).
To view signal connected to PC IN, select
PC.
To view Antenna/Cable channel, select the
desired channel number.
3
When the desired video input mode is
highlighted, press OK.
20DL77_En_new23.indd 23 20DL77_En_new23.indd 23

Chapter 5: Using the TV's features

INPUT:
(Press and hold)
Video2
Video1
2
PC

Tuning channels

Tuning to the next programmed channel
To tune to the next programmed channel:
Press CH s or CH t on the remote control or
TV control panel.
Note: This feature will not work unless you
program channels into the TV's channel memory
☞
( page 22).
Tuning to a specifi c channel (programmed
or unprogrammed)
Press the Channel Number buttons (0–9, 100)
on the remote control. For example, to select
channel 125, press 100, 2, 5.
Tuning to a specifi c programmed channel
(or video mode) using the Program list
Press OK to display the Program list, and then
press s or t to scroll through the Program list.
When the desired channel number (or video
mode) is highlighted, press OK.
9
7
2
PC
Video2
Video1
99
98
Switching between two channels using
Channel Return
The Channel Return feature allows you to switch
between two channels without entering an actual
channel number each time.
1
Select the fi rst channel you want to view.
2
Select a second channel using the Channel
Number buttons (0–9, 100).
3
Press CH RTN on the remote control. The
previous channel will display. Each time you
press CH RTN, the TV will switch back and
forth between the last two channels that were
tuned.
Note: If you press CH RTN from a non-
antenna input, the TV will return to the last-
viewed channel or video input mode.
23
6/13/07 3:50:55 PM 6/13/07 3:50:55 PM