Toro 79348 Manual page 22

Figure 29
Lower Discharge Tube Latch
1. Blower assembly
2. Upper latch
6. Make note of where the 2 bolts in the upper tube
are installed.
Note:
The hole near the molded arrowheads
will not be used.
7. Remove the 2 bolts in the lower end of the upper
tube.
8. Use the 2 holes as a template for the lower tube.
Note:
Retain the hardware.
9. Insert the upper end (no holes) of the upper tube
through the tube seal in the hood by pushing
the tube in until the tube contacts the inside of
the hood.
g018444
3. Latch
10. Pull the upper tube out slightly so that the seal
extends outward and over the lower tube
30).
1. Upper tube
2. Rubber seal protruding out
11. Align the upper tube holes to match the dimples
on the surface of the lower tube.
Note:
Ensure that the side profile appears as
shown in Figure
Note:
Do not use the open hole near the
molded arrowheads.
1. Upper tube
2. Existing hole (bolt
removed)
20
Figure 30
3. Bagger hood
31.
Figure 31
3. Notch at the bottom of the
tube when installed
4. Lower tube
(Figure
g018440
g020776