Starting The Computer By Password - Toshiba Tecra M7-111 User Manual

Power and Power-Up Modes

Starting the computer by password

If you have already registered a password, there are three ways to start the
computer:
Insert an SD card token before you turn on the computer. The computer
will start normally, without displaying a password prompt.
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint System
Boot Authentication. If you would not like to swipe your finger or cannot
authenticate the fingerprint for some reasons, push the BkSp key to
skip the fingerprint authentication screen. You can try to swipe the
fingerprint up to five times. If you failed fingerprint authentication five
times, you must enter the password manually to start the computer.
Log on with the Tablet PC Pen when in Tablet mode. Refer to
mode
Enter the password manually.
The password is necessary only if the computer was Shutdown and
Hibernation in boot mode.
It is not needed in Standby and Restart.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 1,
following message will appear in the LCD:
S
2. Enter the Password.
3. Press Enter.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
6-16
section in this chapter.
Password=
Tablet
Getting Started. The
User's Manual