Set Up Procedure; Fingerprint Registration - Toshiba Tecra M7-111 User Manual

In the help file, it is stated that this software's PasswordBank function can
be used for the Internet and general applications. However, the Internet
PasswordBank function in the fingerprint utility provided in this computer
can only be used with IE (Internet Explorer).

Set Up Procedure

Please use the following procedure when first using fingerprint
authentication.

Fingerprint Registration

Enroll the required authentication data using the "User Enrollment" Wizard.
The fingerprint authentication uses the same Windows logon ID and
password. If the Windows logon password has not been setup, please
do so before registration.
Up to 21 fingerprint patterns can be registered on this sensor.
1. Click start, point to All Programs, point to Protector Suite QL and
click User Enrollment Wizard.
You can also start User Enrollment Wizard using the following method.
Click the Protector Suite QL icon in the Task Bar.
Swipe your finger across the Fingerprint Sensor.
2. Click Next.
3. The User's Password screen is displayed. Ensure the same Windows
logon username is displayed before entering a password into the Enter
your password field. Click Next.
4. The Hints for Fingerprint Enrollment screen is displayed.
Confirm the message and that there is a checkmark in Run Interactive
Tutorial, and click Next.
5. The Correct Swipe Procedure screen is displayed. Confirm the
message and click Next.
6. The Scanning Practice screen is displayed.
You can practice swiping your finger and when you have finished
practicing swiping your finger, click Next.
7. The User's Fingers screen is displayed. Based on the illustration,
select the finger to be recognized, and then click Next. Previously
enrolled fingerprints would have green check marks. The fingerprint
being enrolled now would have a red check mark. If any of the
previously enrolled fingerprints is selected again, the latest information
will be enrolled and previous information over-written.
8. The Advanced Security screen is displayed.
Select whether to enable the security function, and click Next.
9. The Finalization screen is displayed. Click Finish. This completes the
fingerprint registration process.
User's Manual
Operating Basics
4-17