Advertisement
Quick Links
SELF-TESTING NON MAINTAINED EMERGENCY LUMINAIRE WITH WIRELESS COMMUNICATION
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
SUPPLY CURRENT
MIN./MAX. CHARGE CURRENT
CHARGING VOLTAGE
TRICKLE CHARGE VOLTAGE/CURRENT
MIN./MAX. DISCHARGE CURRENT
CUTOFF VOLTAGE
U-OUT
OPEN CIRCUIT VOLTAGE
CONTROL GEAR CHARACTERISTICS
CONTROL GEAR FUSE
CONTROL GEAR MAX. TEMPERATURE
TX/RX FREQUENCY RANGE
TX POWER
BATTERIES (Pb)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
LIGHT SOURCE
EMERGENCY ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
INSULATION BETWEEN SUPPLY & BATTERY CIRCUIT
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
CONTROL GEAR WITH AUTOMATIC
TEST FUNCTION
Do NOT stare at operating light source.The luminaire should be positioned so that
prolonged staring into the luminaire at a distance closer than 1.2m is not expected.
E = 904.8 lux.
thr
GENERAL
These luminaires are used indoors (ta 40 C)
where emergency light is needed. Each luminaire
must be connected permanently to the mains
power supply.
Page 1 from 5
GRL-37/90/WP/WL
POWER-CHARGE indicator, LAMP FAULT–BATT. FAULT indicator, TEST button
EN 60598-1, EN 60598-2-22, EN 55015, EN 61547, EN 61000-3-2,
EN 61000-3-3, EN 62311, ETSI EN 303 446-1 V1.1.0, ETSI EN 300 220-2 V3.1.1
Thank you for your trust in our products
Olympia Electronics - European manufacturer
o
(for LED MODULE Specifications see page 4)
220-240V AC/50-60Hz
13.3W/14VA
63 mA AC
230/710mA
14.7V
13.7V/25mA
1.7A/2.3A
10.8V
18V
23,5V DC
Prated = 21.6W, Irated = 1.2A
8A/250V FB, 5x20mm
o
tc = 75 C at R11
868.150-868.450MHz
11dBm
12V/7Ah
From overcharge and deep discharge
<24h
90 mins
White power LEDs
3200lm
IP65
5 to 40 C
Up to 95%
Basic Insulation
Aluminium, ABS/PC, PC
307 x 100 x 333 mm
4260gr
3 years (1 year for the battery)
WIRELESS COMMUNICATION
The WL luminaire models have the ability to
communicate over the air with Olympia's control
panels for wireless emergency luminaires. The
luminaires can also communicate with a PC/laptop
through a gateway (Ethernet, Wi-Fi, USB). For
more information, please refer to Wireless
Emergency Lighting guides, available on the
company's website.
GRL-37/180/WP/WL
2x12V/7Ah
180 mins
o
6450gr.
923037018_09_001
Advertisement
Related Manuals for olympia electronics GRL-37/90/WP/WL
Summary of Contents for olympia electronics GRL-37/90/WP/WL
- Page 1 1.2m is not expected. E = 904.8 lux. Thank you for your trust in our products Olympia Electronics - European manufacturer GENERAL WIRELESS COMMUNICATION These luminaires are used indoors (ta 40 C) The WL luminaire models have the ability to where emergency light is needed.
- Page 2 OPERATION DESCRIPTION connected). During this test the lamps are turned When the unit is connected to the main power ON for 3 seconds using the batteries. In some supply (after connecting the battery) the indicator cases this function might not be acceptable (i.e in LAMP FAULT –...
- Page 3 Button functionality: Wireless Communication The on-board button has the two following indications (interior) functions: The top LED (LD3-green) indicates the 1. Short press (<2"): a status message will be sent to the Gateway device of the network connection status. wireless network. This LED may blink according to the following patterns: 2.
- Page 4 INSTALLATION PROCEDURE (For wall mounting only) Mounting holes Fig. 1 Cover retaining screws POWER LAMP FAULT CHARGE BATT. FAULT indicator indicator TEST button 1. Use the supplied mounting accessories to mount the device (Fig1). 2. Remove the four cover retaining screws (Fig 1). 3.
-
Page 5: Labeling Explanation
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.