Table of Contents
Advertisement
Q6
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q7
The indicated current time and date
are not correct.
Strong magnetism or impact can cause the
hands and/or the indicator to go out of
alignment. Adjust hand and/or day indicator
alignment.
Adjusting Hand and Day Indicator
l
Alignment
Check the information below to find out how
●
to align the hands and/or day indicator
manually.
Adjusting Hand and Day Indicator
l
Alignment
Q8
The time setting is correct, but the
day indicator is between days.
Is the date setting being updated?
For information about how the day
changes, see the section below.
Hand and Day Indicator Movement
l
Other than the above.
The day indicator is not aligned correctly.
Adjust day indicator alignment.
Adjusting Hand and Day Indicator
l
Alignment
Check the information below to find out
●
how to align the hands and/or day
indicator manually.
Adjusting Hand and Day Indicator
l
Alignment
Operation Guide 5560
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately 30 minutes in the case of hand
and day indicator alignment), crown
operations will automatically become
disabled. Push the crown back in to its normal
position and then pull it out again to re-enable
crown operations.
Using the Crown
l
Q2
Crown operation does not work.
Crown operation is disabled while high-speed
hand movement is in progress after a watch
setting is changed, etc. Wait until the hands
stop moving before performing crown
operations.
Charging
Q1
The watch does not work even
though it is exposed to light.
The watch stops operating whenever the
battery goes dead. Keep the watch exposed
to light until it recharges sufficiently.
Solar Charging
l
19
Advertisement
Table of Contents
