Bellfires DERBY SMALL 3 LF Instructions For Use & Manual Daily Maintenance page 16

Bellfi res
You can cycle through the menu with operating possibilities by repeatedly depressing
the SET button:
16
At the selected starting time (P1
time (P1 or P2 ) is also shown.
Returning to is also possible by pressing the
fl ame) or (large fl ame) button.
Manuel operation
Here you can turn the burner on and off, and adjust the
height of the fl ames.
• Press (large fl ame) to turn on the burner and to
increase the fl ame height.
• Press (small fl ame) decrease the fl ame height to
turn the burner off.
The pilot light will keep burning. (Stand-by position)
• The appliance will automatically revert to stand-by if
the batteries in the receiver are fully depleted. (The
pilot light will also be turned off.)
This also applies to the Thermostat and Timer operation.
• When one of the buttons on the hand-held transmitter
is pressed (except the SET button), the transmission
symbol
confi rms the transmission with an audio signal.
Operating day temperature thermostat
(The appliance must be in the standby position and the
pilot light is burning.)
Automatic temperature regulation of the pre-set day
temperature. The room temperature is measured and
compared with the pre-set day temperature. The fl ame
height is automatically regulated so as to reach the
pre-set day temperature.
Also see: Setting the desired temperature.
and back to
appears on the screen. The receiver
English
or P2 ) or stopping
(small
Instructions for use