3
WORK
3.8
Removing rear fairing
3.9
Fitting rear fairing
3.10
Fitting the rear footrest bracket
Info
The operations are the same for the left and right sides.
Preparatory work
–
Remove the seat. (
Main work
–
Remove screws
201924-10
–
Remove screws
–
Open the filler cap. (
–
Take off the rear fairing.
–
Close the filler cap. (
100314-10
–
Position the license plate holder and cable harness.
–
Open the filler cap. (
–
Position the rear fairing and grab handles
tighten the screws of the grab handles.
–
Close the filler cap. (
–
Fit and tighten the screws on the rear fairing.
Guideline
Remaining screws, chassis
100315-10
–
Mount and tighten screws
–
Tighten the screws of the grab handles.
Guideline
Screw, handrail
–
Mount the seat. (
100314-10
–
Position the footrest bracket
Guideline
Screw, rear footrest bracket
100316-10
p. 6)
.
1
.
2
p. 8)
p. 8)
p. 8)
1
p. 8)
.
2
p. 6)
. Mount and tighten screws
1
as shown in the figure. Fit and slightly
M6
10 Nm (7.4 lbf ft)
M8
20 Nm
(14.8 lbf ft)
.
2
M8x16
25 Nm
(18.4 lbf ft)
9