Dexter Laundry WN0675 Parts And Service Manual page 39

Cycle Settings
A cycle can be edited by clicking on the cycle name in the Cycles page. The name and
language can be customized for that specific cycle. Changing the language for a cycle will
change the status, stage names, and prompts displayed during that particular cycle.
Tip: If a location has multi-lingual employees, the same cycle can be duplicated and
programmed for different languages. For example, in a location with English and Spanish
speaking employees, program White Sheets to the desired settings. Copy that cycle, set that
cycle language to Spanish, and note the name change to Sabanas Blancas. This will allow all
employees to read the necessary prompts and descriptions on the control.
Stages
A stage can also be considered a bath, such as prewash, wash, rinse, etc. Each cycle can
consist of 20 unique stages. Within each stage, the following parameters can be selected.
Setting Options
Bath Temperature
Fill
Auxiliary Temperature
(Heated Models Only)
Water Level
Injection Type 1 – 3
Soap /
Chemicals
Injection Delay
Injection Duration
Options
Hot
Warm
Cold
No Fill
No Heat
100F (38C) – 195F
(91C)
Low
High
None
Detergent Flush
Softener Flush
Chemical 1-10
0 – 150 seconds
1 – 240 seconds
Description
Heated models only. Temperature
is programmable in 5
O
increments.
These settings can be controlled
by the electronic pressure sensor.
Three unique soap options are
available for each stage.
See optional settings for setting
chemical injection details.
If Delay Fill is ON this is the time
from when the low water level is met.
If Delay Fill is OFF this represents
the time from start of the stage to
when chemical injection begins.
The amount of time chemicals will
be injected.
Part # 8533-126-001 11/21
F / 3 C
O
39