Ubiquiti NanoBeam M2 Quick Start Manual page 4

All manuals and user guides at all-guides.com
Reset Button
Reset button for more than 10 seconds while the NanoBeam
is already powered on. Alternatively, the NanoBeam may be
reset remotely via a Reset button located on the bottom of the
PoE Adapter.
Ethernet Port
and should be connected to the LAN and DHCP server. Power
can be provided by any of the following:
• PoE Adapter (included)
• Ubiquiti Networks EdgeSwitch
• Ubiquiti Networks EdgeRouter
LEDs
To reset to factory defaults, press and hold the
The Ethernet port is used to connect the power
Power
The Power LED will light blue when the
device is connected to a power source.
Ethernet The Ethernet LED will light steady blue
when an active Ethernet connection is made and
flash when there is activity.
Signal
The default values are shown below:
LED will light blue when the wireless signal
strength is equal to or above -94 dBm.
LED will light blue when the wireless signal
strength is equal to or above -80 dBm.
LED will light blue when the wireless signal
strength is equal to or above -73 dBm.
LED will light blue when the wireless signal
strength is equal to or above -65 dBm.
™
PoE
™