Changing The Basic Settings; Sabbath Mode; Starting Sabbath Mode; Cleaning - Siemens HB458GC 0B Series Instruction Manual

Table of Contents

Advertisement

Sabbath mode

en

Changing the basic settings

The function selector must be set to the "Off" position.
Press and hold the
v
1.
4 seconds.
The first basic setting will appear on the display,
e.g.
.
™‹‚ ‚
Turn the temperature selector to change the setting
2.
as required.
Use the
@
button to navigate to the next basic
3.
setting.
Using the
A
or
@
button, continue going through all
4.
the basic settings as described above, changing the
settings if necessary using the temperature selector.
When you have finished, press and hold the
5.
button again for approximately 4 seconds to
v
confirm the settings.
All basic settings have now been applied.
You can change the basic settings again at any time.
Your changes to the basic settings will be
Note:
retained even after a power failure.
FSabbath mode
S abbath mode lets you set a cooking time of over 70
S a b b a t h m o d e
hours. This enables you to keep dishes in the cooking
compartment warm without having to switch the
appliance on or off.

Starting Sabbath mode

Before you can use Sabbath mode, you will need to
activate it in the basic settings. ~ "Basic settings"
on page 17
The appliance heats up with top/bottom heating. You
can set a temperature between 85 °C and 140 °C. The
cooking time can be adjusted to the nearest half hour
between 24 and 72 hours.
Set the function selector to the
1.
†'››
appears on the display.
Use the temperature selector to set the temperature.
2.
Touch the
button twice.
v
3.
The cooking time
x
display.
Use the
or
button to set the cooking time.
@
A
4.
The end time cannot be delayed.
Note:
The appliance will start heating after a few seconds. The
remaining time will count down on the display.
When the cooking time for Sabbath mode has ended,
an audible signal will sound. The appliance will stop
heating. The time on the display will be zero.
Switch the appliance off by turning the function selector
to the "Off" position.
Changing and cancelling
The settings cannot be changed once the appliance
has started.
18
button for approximately
programme.
X
will be highlighted on the
If you would like to cancel Sabbath mode, switch the
appliance off by turning the function selector to the "Off"
position.
DCleaning
W ith good care and cleaning, your appliance will retain
C l e a n i n g
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.

Suitable cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Depending on the appliance
model, not all of the areas listed may be on/in your
appliance.
Caution!
Risk of surface damage
Do not use:
Harsh or abrasive cleaning agents,
Cleaning agents with a high alcohol content,
Hard scouring pads or cleaning sponges,
High-pressure cleaners or steam cleaners,
Special cleaners for cleaning the appliance while it is
hot.
Wash new sponge cloths thoroughly before use.
Highly recommended cleaning and care products
Tip:
can be purchased through the after-sales service.
Observe the respective manufacturer's instructions.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the
interior surfaces of the cooking compartment or the
heating elements. Always allow the appliance to cool
down. Keep children at a safe distance.
Area

Cleaning

Appliance exterior
Stainless steel
Hot soapy water:
front
Clean with a dish cloth and then dry with a soft
cloth.
Remove flecks of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corrosion
can form under such flecks.
Special stainless steel cleaning products suitable
for hot surfaces are available from our after-sales
service or from specialist retailers. Apply a very
thin layer of the cleaning product with a soft cloth.
Plastic
Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use glass cleaner or a glass scraper.
Painted surfaces
Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.

Advertisement

Table of Contents
loading

Table of Contents