Table of Contents
Advertisement
Replacing the Lamp
CAUTION!
To replace the lamp, first switch off the power and wait 60 seconds, then, after the
cooling fan has stopped, switch off the main power switch and disconnect the
power plug from the outlet. Now, wait about 60 minutes before replacing the lamp.
Attempts to replace the lamp during operation or immediately after operation has
stopped will cause burns because of the high temperature.
1
Open the Projector Mounting Adapter
Remove the two screws from the front face of the projector mounting adapter.
Place your hand underneath the projector so that the mounting adapter does not
open suddenly.
CAUTION!
Be careful not to catch your fingers when opening or closing the projector
mounting adapter.
2
Replacing the Lamp
Please refer to the instruction manual of the replacement lamp kit (Model
VT70LP/VT75LP).
WARNING!
When performing the lamp replacement work, take care not to exert force on the
projector. Application of a large force could cause the projector to fall and cause
injury.
3
Return the Projector to the Original Condition
Follow the procedure in the reverse order to fix the projector mounting adapter in
place.
13
Advertisement
Table of Contents
