NETGEAR WG311v3 Reference Manual page 34

Reference Manual for the NETGEAR 802.11g Wireless PCI Adapter WG311v3
3. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
Note: For instructions on configuring static IP addresses or the IPX protocol, refer to the
networking tutorial on your NETGEAR 802.11g Wireless PCI Adapter WG311v3
Resource CD.
b. Restart the PCs.
4. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
192.168.0.1
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to "reply."
At this point the connection is established.
You may need to reboot in certain Windows operating systems such as Windows 98.
Note: If you cannot connect, see
have problems accessing network resources, the Windows Client and File and Print Sharing
software might not be installed and configured properly on your computers. Please refer to
"Preparing Your Computers for TCP/IP Networking" on page
3-6
and then click OK.
"Basic Troubleshooting Tips" on page 2-12. Also, if you
C-1.
Configuration
ping -t